Part of trying the get my dishwasher to drain https://piefed.ca/c/diy@slrpnk.net/p/894317/help-fixing-my-dishwasher-it-won-t-drain-and-is-stop-on-sanitize-mode

I have removed to drain pump, solenoid, water heater.

The drain pump white part spins with no obstruction at all.

With a multimeter:

My solenoid is about to get 984 OHMs resistance.

I’m not sure how to check my drain pump. I don’t see any connector end. Closest thing are these 6 metal spike thing pointed out on the motherboard.

I don’t see any visible blockage.

I’m not sure if I need to check the voltage as well. And I’m not sure if i need the dishwasher running with water to test. Problem is still stuff is located at the bottom of the dishwasher. If I wanted to check the voltage with running water.

  • dudesss@piefed.caOPEnglish
    2·
    13 hours ago

    I’m not sure where to apply my multimeter to test the coils

    Closest thing I can find in this end sticking end which connects to the electronics.

    Edit: Testing to the right metal parts of that connector gave me Ohms 128.8

    • AbidingOhmsLaw@lemmy.mlEnglish
      2·
      13 hours ago

      Looks like there are 3 coils wired in a Y formation, so the silver rectangles are where the electrical contact is made, let’s call them 1,2, and 3. If you measure across any 2 points you should get the same ( or close) ohm reading. In this set up you are measuring across 2 of the coils so measuring 1 & 2 then 1 & 3 then 2 & 3 should all be simalar and should not read 0 or infinity.

        • iocase@lemmy.zip
          2·
          13 hours ago

          Blown pump then if you can’t read anything on those pairs. They’re literally physical coils that should always pass current no matter what, and all of the smarts happens inside the control board for making the 215Hz @ 55V & 3A to feed it.